在生产中,根据工艺的需要,电动机要时停时转,前c间戢控制。图所示电。路可以实现这种控制方式。台上电冁开关Qs和手动开关SA,交流接触器KM1和时间继电器KTI得电吸合,KM主触头闭合,电葫机M起动运行...
2023-01-22 279 控制电路
在生产中,根据工艺的需要,电动机要时停时转,前c间戢控制。图所示电。路可以实现这种控制方式。台上电冁开关Qs和手动开关SA,交流接触器KM1和时间继电器KTI得电吸合,KM主触头闭合,电葫机M起动运行...
2023-01-22 279 控制电路
电动机从切断电源时起到完全停止转动,由于惯性的原因,总要经过较长一段时间才能停转。这对有些生产机械是不适应的,如起重机的吊钩需要立即减速定位,万能铣床要求主轴迅的停转等,为了迅速停机,就要对电动机采用...
2023-01-22 342 电动机
图机床工作台自动往复运动示意图 图行程开关正反转自动循环控制电路工作过程:按下正向起动按钮SB2,接触器KM1得电动作并自锁,电动机正转使工作台前进。运行到SQ2位置,撞块压下SQ2,SQ2常闭触点使...
2023-01-22 352 正反转
断电限位器也称断火限位器,它广泛应用在工矿的起重行车上。使用断电限位器应注意以下几点:1.接线时按照线路图连接进入的5根电源线,接好后,再把电动机负荷线接在断电限位器的接线端子上。2.在使用断电限位器...
2023-01-22 397 电动机
由TOP224P构成的 12V、20W开关直流稳压电源电路如图所示。电路中使用两片集成电路:TOP224P型三端单片开关电源(IC1),PC817A型线性光耦合器 (IC2)。交流电源经过UR和C...
2023-01-22 313 稳压电源
z3050型摇臂钻床电气原理图: Z3050摇臂钻床主要由底座、内立柱、外立柱、摇臂、主轴箱、工作台等组成。内立柱固定在底座上,在它外面套着空心的外立柱,外立柱可绕着内立柱回转一周,摇臂一端的套...
2023-01-22 328 摇臂钻床