如图所示是一个数字式的电容测量电路,采用数字计数方式显示电容量大小,可大为提高。这里采用555作为计数门控电路,可达0.5%.K1-1与K1-2是同步动作的量程选择开关,这里设有3档量程(10μF...
2024-01-30 174 电容 开关 电容器
此电路是用于具有455kHz中频的80米波段接收机中的LC振荡电路。 740 this.width=740" height=229˃ LC振荡电...
2024-01-30 137 接收机 电感 电容 变压器
单斜率A/D转换器提供了直流输入电压的高速转换到数字数据输出。对于0到10V的输入,100兆赫时钟的1024脉冲出现在满量程,在半量程的时候是512。当指令脉冲被运用,2N914晶体管复位1000p...
2024-01-30 165 转换器 2N914 晶体管 电容
超再生检波接收器:超再生检波电路实际上是一个受间歇振荡控制的高频振荡器,这个高频振荡器采用电容三点式振荡器,振荡频率和发射器的发射频率相一致。而间歇振荡(又称淬装饰振荡)双是在高频振荡的振荡过程中...
2024-01-30 172 接收器 振荡器 电容 发射器 继电器
在这个电路中,通过使用一个传统的运算放大器和反馈电容Cf就可以实现集成。当积分器的输出经过LM131的引脚6的阀电平时,计时开始。到达运算放大器的平均电流的总和点(引脚2)为i×(1.1 RtCt ...
2024-01-28 149 运算放大器 电容 LM131 引脚 放大器
本电路采用了由OP放大器构成的(全波整流 ,由均化电容转换成输入信号的平均值,在输入电压很小时也能获得高。本电路可用来测量交流信号电压,也可用来把交流信号转换成直流信号。运算放大器A1是放大倍数...
2024-01-28 142 放大器 电容 运算放大器
该闭塞振荡器回扫电路是电离箱电容的充电备用选择。 ...
2024-01-28 166 振荡器 电容
图5-76是采用U2402B构成的带定时控制的充电电流。定时器采用4060,采用Q13(2脚)产生的高电平输入至U2402B的7脚使充电器复位而停止充电。每当上电时,电容C12开始充电,12脚为高...
2024-01-28 198 U2402B 定时器 充电器 电容
电压倍增器是由二极管(D1和D2)和一对电容(C1和C2)组成,在这种情况下,该电容由一个12V 1A降压变压器(T1)提供。 ...
2024-01-28 166 二极管 电容 变压器
在自触发模式中,简单的变压器功率转换器使用555定时器作为方波发生器。电压倍增整流器跟随在他后面。所示的R和C的值提供的频率大约是20兆赫,它允许带有相对较小的电容过滤。的负载电流大约是80mA。&n...
2024-01-28 151 变压器 转换器 定时器 发生器 电容