继电器延迟吸和电路由平面晶体管BC107C以及其他外界元件构成。由于晶体管有很高的电流放大系数和小的集电极电流,故延迟可达60ms。如果再小,则应采用更小的电容。 ...
2023-10-30 198 继电器 晶体管 BC107C 晶体 电容
追逐式彩灯控制器电路 如图为追逐式彩灯控制器电路。接通电源后,电容器C3,C2,C1经过D3,R5;D2,R3;D1,R1分别充电。由于元件参数误差,三个电容器充电电压不可能完全相等,设C2充电...
2023-10-30 202 控制器 彩灯控制器 电源 电容器 电容
NE555是属于555系列的计时IC的其中的一种型号,555系列IC的接脚功能及运用都是相容的,只是型号不同的因其价格不同其稳定度、省电、可产生的振荡频率也不大相同;而555是一个用途很广且相当普...
2023-10-30 219 电容 电阻器 电容器 电源 MOS
在实验中,偶然发现单向可控硅(MCR100-8)控制极在不需要加正向电压的情况下,只要用手触摸一下,就会导通,因此,小编设计了一种简单的触摸开关,电路如下图所示。触摸一下金属片开,SCR1导通,负载得...
2023-10-30 239 开关 电容
输出电流感应经过R8,然后流经R7到达限流放大器,再通过由R6和D4控制的阀值组成折返。阀值使得峰值功率低于20瓦,并且当流经的电压超过310伏的时候会切断晶体管电流。由于未经调节的电压时常大于该阀值...
2023-10-30 158 放大器 晶体管 电容
一个单稳态555定时电路被光的显著光敏电阻触发。通常的电阻都是几百万欧姆的,但是,在有光的条件下,电阻降低到只有几百欧姆,这样来自6V电源的电流就可到达电路中。如图所示的电阻-电容提供了大约两分钟的持...
2023-10-30 164 光敏电阻 电阻 电源 电容
用于U1的音频信号需要先经过741运算放大器U2。在被U2放大后,输出信号经过采样,然后用于一个负倍压器或者整流器电路中,倍压器/整流器电路是由二极管CR1,CR2和电容C1组成。产生的负电压可用作2...
2023-10-30 167 运算放大器 二极管 电容 场效应管
一个调谐哈特利振荡器电路可产生超高频率。电阻R2,R3和R4偏置电阻,抽头电感器L1和调整式电容C1组成振荡电路。调整C1以控制频率。电容C2可提供从振荡电路中来要到Q1的发射极去的正反馈。 ...
2023-10-30 168 振荡器 电阻 电感器 电容
该电路使用两个二极管,是一个峰间值限制器。电容为一个由峰间音频信号和削波控制的直流电平供电。如果噪音超出了该电平且二极管降低的话正负峰波就会被裁减。为了达到的效果,该电路应该在几伏的电平条件下使用。&...
2023-10-30 208 二极管 电容
这种单时间常数电路可用于当负载固定时异步马达譬如罩极或分裂电容马达的正比速度控制。这个电路适用于需要在满功率下控制速度至中等水平。 ...
2023-10-30 183 马达 电容