LM324构成的单、双电源通用四运算放大电路 LM324系列器件为价格便宜的带有真差动输入的四运算放大器。与单电源应用场合的标准运算放大器相比,它们有一些显著优点。该四放大器可以工作在低到3.0...
2023-10-21 144 电源电路 电路图
该电源开路时提供约6kV直流电,下降到大约1375伏直流电时加载。R099是激光管。 来源:zhenglili...
2023-10-21 114 电源电路 电路图
RH5RI∕H的优点是能低电压工作,最高输出电压没定为7.5V,若输出电压超过7.5V,要外接稳压二极管VD1来实现。如左图示,电路中二极管VD3用于构成以功电路,右图是采用RH5RI∕H构成...
2023-10-21 127 电源电路 电路图
下面是基于AD790的可调式恒温控制器电路。由REF01E给TMP17提供高稳定度的10V电源电压,在电阻R1上可获得与被测温度t成正比的电压信号。AD790为电压比较器。令t、t0分别表示温度的...
2023-10-21 99 电源电路 电路图
把直流电变为交流电的过程称为逆变。逆变充电电路就是通过逆变器把直流电压变成交流电压,然后经过升压或降压再整流后给储能器充电。在逆变器中,如果开关元件选用晶闸管,那么该电路称为晶闸管逆变器。用晶闸...
2023-10-21 122 电源电路 电路图
该电路采用555定时器驱动4017计数器。计数器输出驱动晶体管继电器驱动器。通过改变计数器输出连接,时间指示灯“ON”。 来源:zhengwei...
2023-10-21 120 电源电路 电路图
原理电路如上图所示,图中C1为路能电容器,T1为雪崩晶体管,Rl为负载。由于Rl加在T1发射极,实际工作中相当于在T1基射间加反向偏压的情形。所以,用上图(b)分析雪崩晶体管的工作...
2023-10-21 103 电源电路 电路图
下图是UC3907(点划线框)与外部电路的连接方式。电流信号由外部分流器弘采样,RCS一般串联在功率输出的返回支路,通过2脚或3脚引入电流放大器,电源模块的输出电压采用信号由11脚和4脚差动输人...
2023-10-21 92 电源电路 电路图
镍镉电池可重复500次以上的充放电,经济耐用。其内部抵制力小,既内阻很小,可快速充电,又可为负载提供大电流,而且放电时电压变化很小,是一种非常理想的直流供电电池。它是最早应用于手机、超科等设备的电...
2023-10-21 112 电源电路 电路图
电路如图2-25所示,T1和T2组成复合管作为开关调整器件,该电路也工作于自激状态。调整器件受以μA723为核心的电路控制,反复导通与截止,其周期取决于输入电压、滤波电路及负载的大小。 图2...
2023-10-21 109 电源电路 电路图