如图所示拓扑具有一个互补差动输入级。在该拓扑中,放大器的输入位于负轨附近时,PMOS晶体管为"开",而NMOS晶体管"关".当放大器的输入更接近于正电压轨...
2023-10-21 132 电源电路 电路图
能够实现自驱动的电路如图所示。 该电路的优点有: ①拓扑结构简单②控制效果较好③采用的元器件较少 缺点有:①仅适于次级工作电压不高不低的情况,工作电压太高或太低都会影响MOSFET 的正常...
2023-10-21 126 电源电路 电路图
本电路由晶体管Q2和电阻R3~R7组成过载保护电路。在Q1截止前,其发射极电压一直减小,输出电压也开始减小。于是,由于R7的电压反馈使Q2的发射极电压减小,进一步使Q2导通,结果Q1...
本电路中采用两只二极管来减小电压的过渡瞬变。当Q1接通时,二极管D1导通,D2隔绝了Q1基极上的正向偏压;当Q1断开时,它的基极上的负放电电压,这时却经过二极管D1加到了发射极,产生...
2023-10-21 111 电源电路 电路图
过压保护OVP(overvoltage protection),当被保护线路的电源电压高于一定数值时,保护器切断该线路;当电源电压恢复到正常范围时,保护器自动接通。 &nb...
2023-10-21 106 电源电路 电路图
如图所示,本电路把一个全波电桥和灵敏继电器接在相位顺序指示器上。当接入正确的相序,ABC灯将发亮,继电器接通控制电路,从而使其工作。相序反转时,BAC灯发亮,继电器未接通控制电路,电...
2023-10-21 94 电源电路 电路图
工作原理:Rp1~Rp(n)是+5V电源线的PCB电阻,阻值均为1mΩ;Rn1~Rn(m)是GND地线的PCB电阻,阻值均为1mΩ;C1~C5是+5V电源的退耦电容。假设在电容C2...
一个LM2574用来从5V的逻辑母线产生出电流为0.5A的3,3V的电压,其占空比为: (Vout+Vd-Vsnd)/(Vin-Vsa7+Vd-2Vind) Vd=二极管的电压降 Vind=...
2023-10-21 120 电源电路 电路图
该稳压器可与6V电源一起供给ZN416E的低压TRF(射频调谐)无线接收器集成电路所必需的+1.5V电压,电阻R3用来调节输出电压。 来源:阴雨...
2023-10-21 133 电源电路 电路图
电路如下图所示。本铅酸蓄电池维护电路采用PIC16F676单片机作主控制器,通过本装置,利用普通充电电路平时对电池充电的同时。利用本装置检测电池电压充电阶段和时间,通过核心芯片单片...
2023-10-21 122 电源电路 电路图